The Federal Aviation Administration said Tuesday it is pausing the installation of the new routers linked to last week’s nationwide ground stop and has turned off the Juniper routers that were already installed, the Associated Press reported. The Wall Street Journal, CNN, CNBC, ABC News and Bloomberg also reported the pause.
According to the AP, technicians traced Friday’s disruption of key air traffic control systems to one of the new routers, which had just been installed in El Dorado, Arkansas, by contractor L3Harris. The routers that failed are now being tested in a lab at L3Harris headquarters. For now, the FAA is relying on older Cisco routers that have been in service for 25 years.
‘1,000 connection attempts every 4 to 5 seconds’
The FAA said “excessive data” flooded the system “at a rate of 1,000 connection attempts every 4 to 5 seconds,” overwhelming the 25-year-old routers and destabilizing “aircraft communications and radar feeds” at 17 of the nation’s 22 regional air traffic control centers, the AP reported. Transportation Secretary Sean Duffy has said the airspace closure was needed after the cascade of intermittent communications and radar failures.
The political fight
Democrats on the Senate Commerce Committee sent Duffy a letter Tuesday calling for a stop to the router replacements until the root cause is found. “Identifying the device that failed does not establish why it failed,” the letter said, according to the AP. The Democrats said they believe only about 400 of more than 3,600 routers have been installed.
President Trump has blamed old technology and Democrats for the grounding. The AP noted the FAA’s struggle to modernize air traffic control goes back decades, to well before Trump’s first term.
Sources: Associated Press, Wall Street Journal, CNN, CNBC, ABC News, Bloomberg.







Leave a Reply